A central vacuum system can support vacuum and cooling demand from one or more EPS pattern molding machines. Pumps, condensation, controls, piping, and drainage are arranged for the project.
The number of machines is only the first input. Demand overlap, pipe distance, elevation, cooling, condensate load, drainage, redundancy, and utilities affect the design.
This page covers white-area support for EPS pattern molding. It does not describe a black-area flask or pouring vacuum system.
A project may include vacuum pumps, condensation or separation equipment, controls, valves, instruments, piping, and drainage interfaces. The exact package depends on the molding machines and plant.
Available configurations can include PLC control and centralized support. Component brand, quantity, material, and standby philosophy are recorded in the project proposal.
Long routes, small pipe sections, poor slopes, and unplanned condensate points can change system behavior. The equipment room also needs ventilation, service clearance, and safe electrical access.
A line diagram and factory layout should be reviewed before selection is frozen. Water-discharge or heat-recovery claims must match the final design.
Pressure, flow, pump power, condensation, and recovery arrangements are calculated from machine demand, pipe losses, operating overlap, and site conditions.
The acceptance basis states measurement points, operating combinations, utilities, and test conditions for commissioning.
No. It supports EPS pattern molding and related cooling or condensate handling in the white area. Flask vacuum, pouring, and sand systems are outside the current offer.
Yes, subject to review. Machine demand, simultaneous operation, pipe losses, condensate load, redundancy, and expansion affect the required arrangement.
Those values depend on connected machines and layout, and older source files conflict. Current project data will be calculated and stated in the technical offer.
Share the casting type, target output, available utilities and current process. That makes the first technical review more useful.
